Also remove and discard the seat.
Miata roll bar install instructions.
These pieces are called quarter trim by mazda first remove.
2 remove the trim panels covering the seat belt towers.
First part here https youtu be fwuvak1lt9u autox fun in this car here https y.
Install the upper mounting bolts through the upper mounting plate with the spacer under the.
Second part of the installation of the hard dog roll bar into a nc miata.
We worked with hard dog to give you as much overhead protection as possible.
3 remove the lower seat belt reel bolts 16mm pre 94 17mm 94 and later and spacers.
Do not believe claims to the contrary.
The original spacers fig 1 once the hard bar and those rascally seat belt reels are in position start but do not completely tighten the footplate mounting bolts from the hardware kit make sure that your seat belts are on the inside of the roll bar.
The roll bar plates fit against the seat belt reels which stay in their original location but do not use the original spacers.
Roger our region s president has been doing some local autocrosses lately and i guess he got to thinking about what might happen if he tried jumping a curb at full tilt like he did one time ask him about it sometime and got it upside down.
Fig hc2 once the bar and the seat belt reels are in position snug but do not completely tighten the seat belt reel mounting plates using bolts from the hardware kit and small od flat washers from the stock bolts.
Remove the package tray cover about ten 10mm bolts and remove the seat belts from their receptacles by prying off the plastic cap from the seat belt harness restraint and removing the 19mm iirc bolt save this bolt because you are going to reuse it to secure the bar to the top of the seat belt tower and 10mm screw on top and 17mm bolt on the bottom and lay the seat belt mechanism to the side.
Miata hard dog roll bar installation by john kuykendall.
Remove the carpet and padding from the vertical wall behind the seats.
Flyin miata is the world leader in miata performance.
We offer a wide range of parts for all years of the mazda mx 5 miata.
This bar is legal for use with nasa.
With the top partially raised roll or fold the horizontal package tray carpet back under the convertible top.
Using a small crow bar claw hammer or button removal tool carefully pry the plastic buttons from the carpet at the front edge of the package tray.
We believe there is an excellent chance this bar will fit a 124 spider but we have not been able to confirm yet.
